The hot dip galvanized slotted angle bars are designed for the parallel deployment of telecom cables on poles initially dedicated to low voltage networks, and they are widely used on wooden poles and concrete poles. The slotted angle bars are widely used for the parallel deployment of overhead lines. This cross-arm angle brackets are installed on a pole bracket adapted for its mounting support, and this pole line hardware brackets are used as fastening points for suspension applications.
Specifikation
Stålkvalitet: Q355B motsvarande S355JR EN10025
Draghållfasthet: 470-630MPa
Vinkelstång: 40 mm x 40 mm x 4 mm
Längd: 450 mm, 850 mm, 1050 mm eller anpassad
Hålstorlek: 15 mm, 17 mm och 19 mm eller anpassade
Hålutrymme: 40 mm, 50 mm och 60 mm eller anpassat
Galvanization thickness Greater than or equal to 70μm according to ISO EN 1461
Produktionslösning: stansning eller laserskurna hål före varmförzinkning
Tillverkningstolerans enligt ISO 2768-M
Fabmann supplies a wide range of slotted angle bars with hot dip galvanization for storage racking system, power transmission and telecom industries, and this special cross-arm brackets can lift cables from poles and protect them against environmental constraints. Our production team takes very strict on hot dip galvanization, and the galvanization thickness is no less than 70μm according to ISO 1461. Plus, all the pre-punched holes have very tight tolerance for precise installation at construciton site.
Populära Taggar: Anpassad slitsad vinkelstång, OEM slitsad galvaniserad vinkelstång, kors-armvinkelfäste, överliggande hårdvaruvinkelfäste, poleline vinkelfäste, Galvaniserade delar, Bjälkvinkel, Maskinställfäste, Metallfästen med PEM, Metalltillverkning, Stålfästen











